Some brands provide a simple snap-in type bracket while others utilize mounting screws that go in from the holt science spectrum chemical reactions test side of the brake controller bracket.
Install the brake controller bracket in a convenient location under the dash using the bracket supplied.
The PL code will be displayed when the Prodigy loses voltage on the black wire while either the brake pedal or the manual lever is being applied.
GM/Chevy vehicles have a harness panel located on the driver's side towards the top left.Unlike time-delay brake controllers which send the exact amount of the preset power each time the trailer brakes, these controllers can adapt to win xp service pack 3 patch each braking situation differently.Warranty: It normally comes with a limited life-time warranty.Here are the basic steps to take for the three popular late model trucks/SUV's: Ford, GM/Chevy, and Dodge.If you have a Ford, go to step.They normally help to reduce the installation time.In case you slam on your trailers brakes, they will just activate with the same intensity.
This brake controller is a great breakthrough in the inertia-activated brake controls.
This usually requires drilling two holes to attach the mounting bracket.
Check the ground leads that exit each brake assembly, make sure they are securely grounded to bare metal on the trailer frame.
But, it could also indicate a problem with the rake magnets.
Look for any pinch points, or worn or cracked insulation that would allow the output wire to short out on the trailer frame.Question: I am using a prodigy P2 proportional controler, and having 2-3 trouble codes.See the video above for steps on how to calibrate and test your newly installed brake controller.You simply need to select a boost setting and set the systems initial power level and you will be good.Product Page this Question was Asked From.The system allows for easy transfer between automobiles.This feature enables the user to apply more of the initial braking power especially when towing heavy trailers.