Support the front feet on paint cans while you slip the old belts from the pulleys.
Reinstall the hot and subway surfers hawaii hack cold water feed lines and push the washing machine back into place.
Reinstall the front panel and stand the machine upright.Required Materials for this Project.Required Tools for this Project, have the necessary tools for this DIY project lined up before you startyoull save time and frustration.With one hand, grasp the motor and apply outward pressure while loosening the pump pulley screw.Then prop the front of hakuouki shinsengumi kitan game english the washer up on paint cans so you can reach the belts.You can replace the drive belt yourself in less than an hour, saving the time and expense of calling a repairman to fix the washing machine for you.Reinstall the belts in the reverse order.Take the damaged belt with you to the appliance parts store to get a replacement.The motor on the washer is held on by tension springs, but due to constant movement during operation, the belt can become worn out or break from usage.Step 3, place a wood block upright on both sides under the front of the dryer to stabilize it while you are working underneath the appliance.
Push the pump outward until the slack is taken out of the pump belt and tighten one of the pump screws to hold it in place.
Remove the two screws located on the bottom of the front panel and swing the bottom of the panel out to unhook it from the top.
Belt replacement, photo 1: Check for a jam.Unscrew the water lines from the inlet valve at the back of the machine with a pair of adjustable pliers.Install the transmission belt onto the transmission pulley and onto the inner groove of the motor pulley.Things You Will Need, adjustable pliers, blanket.Photo Credits, george Doyle/Stockbyte/Getty Images.After removing the item, you should replace the damaged belt.As with most Maytag washers, it features two belts connected to the motor.The belt should almost touch in the center when squeezed with moderate pressure.Sometimes, the screws that hold the assembly in place can come loose and add too much slack to the belts.